Atozed Forums › Atozed Software › IntraWeb › English › IntraWeb General Discussion v
Missing entry point in IW15.2.17

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Missing entry point in IW15.2.17
cyracks Offline
Junior Member
**
Posts: 8
Threads: 4
Joined: May 2018
Reputation: 0
Location: Slovenia
#12
09-30-2020, 09:04 PM (This post was last modified: 09-30-2020, 09:08 PM by cyracks.)
Hello

I have similar problem. Delphi 10.4 patch 3, IW 15.2.18, installation is ok, but when I start IDE, the error on the link bellow is shown:

https://pasteboard.co/JtwTcam.png

I tried removing/reinstalling a couple of times, also with IW 15.2.17 but it does not help.

Regards,
Tomaž
Find
Reply


Messages In This Thread
Missing entry point in IW15.2.17 - by JuergenS - 09-18-2020, 08:16 AM
RE: Missing entry point in IW15.2.17 - by I.Igor - 09-18-2020, 10:45 AM
RE: Missing entry point in IW15.2.17 - by I.Igor - 09-25-2020, 08:45 AM
RE: Missing entry point in IW15.2.17 - by cyracks - 09-30-2020, 09:04 PM
RE: Missing entry point in IW15.2.17 - by Hexsol - 10-21-2020, 09:03 AM
RE: Missing entry point in IW15.2.17 - by kudzu - 10-21-2020, 02:08 PM
RE: Missing entry point in IW15.2.17 - by Hexsol - 10-21-2020, 02:28 PM
RE: Missing entry point in IW15.2.17 - by Hexsol - 10-21-2020, 03:52 PM
RE: Missing entry point in IW15.2.17 - by kudzu - 10-21-2020, 04:13 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)